ZX-移动式液压后卸平台 DC-Mobile hydraulic post-discharge platform

ZX-移动式液压后卸平台

ZX-Mobile hydraulic post-discharge platform

功能介绍：

1、卸车功能∶调整平台处于平整地面，并保证承重架体充分落地，然后将料斗、两端引桥挂接在平台两端，即完成平台定位。

当车辆驶入平台后，升降挡轮装置至位置传感器生效后，车辆开始倒车使车尾轮靠紧挡轮装置，即可以开启车门进行卸车。当车门完全打开粮食自流结束时，即可以启动翻板，将车辆缓缓举升，直至粮食完全卸完，操作平台下降。全过程由遥控器操作完成。

2、行走功能:当需要移动平台时，首先将料斗和两端引桥脱离，然后将承载轮升起，使平台离开地面，完全由驱动轮和转向轮支撑。操作遥控器前进或左右，即可以将平台移动到理想位置。全过程由遥控器操作完成。

技术参数：

Function introduction:

1.Unloading function: adjust the platform on flat ground, and ensure that the load-bearing frame body fully fall to the ground, and then the hopper, both ends of the bridge hanging at both ends of the platform, that is, complete the platform positioning.

When the vehicle enters the platform and the position sensor takes effect, the vehicle starts to reverse and make the rear wheel close to the retaining wheel device, that is, the door can be opened for unloading. When the door is fully opened and the grain artefact is over, it can start the turning plate and lift the vehicle slowly until the grain is completely unloaded and the operating platform drops. The whole process is completed by remote control.

2.Walking function: when the need to move the platform, the first hopper and both ends of the approach bridge from, and then the bearing wheel will be raised, so that the platform off the ground, completely supported by the driving wheel and steering wheel. Operate the remote control forward or left or right, that is, you can move the platform to the desired position. The whole process is completed by remote control. 

Technical parameters: